![]() ![]() Start the communication between the access point and the UTM appliance When connected to the network, the access point will try to receive an IP address via DHCP. Note that the AP15 can also be operated through a PoE-injector or PoE-compliant switch. Please use the power supply from the scope of supply. Connect the AP 10 and AP 15 to the power supply. For more information on PoE-injectors, see below. Note that it is also possible to power them by a PoE-compliant switch. 1ģ Connect the access point to the power supply The AP 30, AP 50, and AP 100 can be powered directly through the Power-over- Ethernet-injector. Now connect the access point to your internal network by plugging in the network cable to the access point s RJ45 or LAN (PoE) Ethernet interface, respectively. Connect the access point to the internal network Decide where you would prefer to place the access point, and put the access point in that location. Note that you also need a valid UTM Wireless Protection subscription to operate the Sophos Access Points. Installation AP 10/15/30/50/100 Preliminary steps Please update your UTM appliance to the latest version available. In addition, it easily provides wireless guest Internet access during the initial setup, unless you explicitly deny automatic configuration. The access point will find the controller, fetch its configuration and become operable within seconds. The wireless controller itself centrally manages all wireless access points all you need to do is plug in the device anywhere in your network. It combines affordable and configuration-less access points through a builtin wireless controller in the in Sophos UTM. Introduction UTM Wireless Protection simplifies the operation of secure and reliable wireless networks. You may download all user manuals and additional documentation from the Sophos Knowledgebase at knowledgebase.aspx. In addition, please also see the following documents that contain useful information on safety, regulatory compliance, and configuration options: Ì Ì Sophos Access Points Safety Instructions and Regulatory Information Ì Ì Sophos UTM Administration Guide: Configuring the UTM hardware and software appliance The instructions must be read carefully prior to using the device and should be kept in a safe place. These operating instructions will help you install and configure the access point and provide technical specifications of all Sophos access point models. There is NO warranty not even for MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.2 Foreword We are pleased to welcome you as a new Sophos Access Point customer. This software is distributed under a FreeBSD license. Otherwise the exit status is that of the last sdparm utility called. The exit status of this script is 0 when it is successful. If this option is not given then the SAS disk LED is made to blink for 30 seconds. When NUM > 1 then the SAS disk LED is made to blink for NUM seconds. When NUM is 0 then the RLM field is cleared. OPTIONSĪrguments to long options are mandatory for short options as well. The script use the sdparm utility and manipulates the "Ready LED Meaning" (RLM) field in the Protocol specific port mode page in order to blink the LED. This is meant to help identify which disk corresponds to a given DEVICE. By default the LED will blink for 30 seconds. This bash shell script attempts to blink the LED on the SAS disk referred to by DEVICE. ![]() Sas_disk_blink - blink the LED on a SAS disk SYNOPSIS To read the man page for sas_disk_blink in Linux: ~]$ man 8 sas_disk_blink NAME Linux Home > Manual Sections > 8 > sas_disk_blink sas_disk_blink(8) - Linux Man Page ![]()
0 Comments
Leave a Reply. |